Hyppää sisältöön
    • Suomeksi
    • In English
Trepo
  • Suomeksi
  • In English
  • Kirjaudu
Näytä viite 
  •   Etusivu
  • Trepo
  • TUNICRIS-julkaisut
  • Näytä viite
  •   Etusivu
  • Trepo
  • TUNICRIS-julkaisut
  • Näytä viite
JavaScript is disabled for your browser. Some features of this site may not work without it.

Particulate emissions of a modern diesel passenger car under laboratory and real-world transient driving conditions

Wihersaari, Hugo; Pirjola, Liisa; Karjalainen, Panu; Saukko, Erkka; Kuuluvainen, Heino; Kulmala, Kari; Keskinen, Jorma; Rönkkö, Topi (2020)

 
Avaa tiedosto
Particulate_emissions_of_a_modern_diesel_2020.pdf (2.866Mt)
Lataukset: 



Wihersaari, Hugo
Pirjola, Liisa
Karjalainen, Panu
Saukko, Erkka
Kuuluvainen, Heino
Kulmala, Kari
Keskinen, Jorma
Rönkkö, Topi
2020

Environmental Pollution
114948
doi:10.1016/j.envpol.2020.114948
Näytä kaikki kuvailutiedot
Julkaisun pysyvä osoite on
https://urn.fi/URN:NBN:fi:tuni-202007026307

Kuvaus

Peer reviewed
Tiivistelmä
<p>Exhaust emissions from diesel vehicles are significant sources of air pollution. In this study, particle number emissions and size distributions of a modern Euro 5b -compliant diesel passenger car exhaust were measured under the NEDC and US06 standard cycles as well as during different transient driving cycles. The measurements were conducted on a chassis dynamometer; in addition, the transient cycles were repeated on-road by a chase method. Since the diesel particulate filter (DPF) removed practically all particles from the engine exhaust, it was by-passed during most of the measurements in order to determine effects of lubricant on the engine-out exhaust aerosol. Driving conditions and lubricant properties strongly affected exhaust emissions, especially the number emissions and volatility properties of particles. During acceleration and steady speeds particle emissions consisted of non-volatile soot particles mainly larger than ∼50 nm independently of the lubricant used. Instead, during engine motoring particle number size distribution was bimodal with the modes peaking at 10–20 nm and 100 nm. Thermal treatment indicated that the larger mode consisted of non-volatile particles, whereas the nanoparticles had a non-volatile core with volatile material condensed on the surfaces; approximately, 59–64% of the emitted nanoparticles evaporated. Since during engine braking the engine was not fueled, the origin of these particles is lubricant oil. The particle number emission factors over the different cycles varied from 1.0 × 10<sup>14</sup> to 1.3 × 10<sup>15</sup> #/km, and engine motoring related particle emissions contributed 12–65% of the total particle emissions. The results from the laboratory and on-road transient tests agreed well. According to authors’ knowledge, high particle formation during engine braking under real-world driving conditions has not been reported from diesel passenger cars.</p>
Kokoelmat
  • TUNICRIS-julkaisut [20127]
Kalevantie 5
PL 617
33014 Tampereen yliopisto
oa[@]tuni.fi | Tietosuoja | Saavutettavuusseloste
 

 

Selaa kokoelmaa

TekijätNimekkeetTiedekunta (2019 -)Tiedekunta (- 2018)Tutkinto-ohjelmat ja opintosuunnatAvainsanatJulkaisuajatKokoelmat

Omat tiedot

Kirjaudu sisäänRekisteröidy
Kalevantie 5
PL 617
33014 Tampereen yliopisto
oa[@]tuni.fi | Tietosuoja | Saavutettavuusseloste